Applications for addresses in Poole are decided by BCP Council, which replaced the Borough of Poole in April 2019. The key point for Poole owners is that the council still uses a separate local plan for the former Poole area, so the rules here are not the same as in Bournemouth, even though the same council decides both. Applications can be searched on the BCP planning register.
Poole is in England, so proposals are made under the Town and Country Planning Act 1990 and assessed against the development plan and the National Planning Policy Framework (NPPF, published August 2026).
The Poole Local Plan
The Poole Local Plan was adopted on 13 November 2018 and covers the period to 2033. It sets the strategy for the town centre, where most new homes are planned, and contains Poole-specific policies on housing mix, annexes for extended families, heritage and the harbour. BCP Council is now consulting on the content and evidence for a single BCP Local Plan for 2029 to 2044, with comments due by 21 December 2026, but until that plan is adopted the 2018 Poole Local Plan remains the starting point.
HMOs: only Talbot Village is controlled
Unlike the Bournemouth area, where an HMO Article 4 Direction covers everywhere, the former Poole area has one only in Talbot Village, near Bournemouth University. It came into force on 1 May 2013, and Policy PP14 of the Poole Local Plan is used to avoid harmful concentrations of HMOs there. Elsewhere in Poole, changing a house into a small HMO for three to six people is normally permitted development, subject to the property’s history and any conditions. Larger HMOs need permission everywhere, and licensing is separate.
Heathland, harbour and coast
Much of Poole sits close to internationally protected heathland and to Poole Harbour. New homes near these sites usually have to contribute to mitigation, and proposals close to heathland can be refused because of their effect on wildlife. Waterfront sites in Sandbanks, Lilliput, Hamworthy and around the harbour also raise flood risk and design questions.
Conservation areas
Poole’s conservation areas were reviewed when the Local Plan was prepared. The Town Centre Heritage conservation area now combines the former High Street, Old Town and Poole Quay areas. Others include Ashley Cross, Branksome Park and Chine Gardens, Canford Cliffs Village, The Avenue and Talbot Village. In a conservation area, permitted development rights are narrower, demolition is controlled and trees are protected. Works affecting the character of a listed building need listed building consent.
Common projects in Poole
- Replacement dwellings and large extensions in Sandbanks, Canford Cliffs and Lilliput
- Annexes for family members, which have their own Local Plan policy
- HMO applications in Talbot Village
- Alterations in the Old Town and Quay
- Proposals near heathland or the harbour
How we can help
We advise on planning permission in Poole, including replacement dwellings, householder applications, HMO planning, change of use and appeals. We confirm that the Poole documents apply, then check heathland, flood and conservation area constraints for the address.
We cannot guarantee that BCP Council, or an Inspector on appeal, will grant permission.
What to send us about a Poole project
Use the form below to send us the property address in Poole, a short description of what you would like to build or change, and any drawings, photos or previous decision notices you have. If the property is in Talbot Village or close to heathland or the harbour, please mention it, as extra controls may apply.
Planning policies and validation requirements can change. We confirm the relevant local authority and current policy position for each instruction. A city service page does not represent a staffed local office.
Ask about planning in Poole
Tell us about the property and what has happened so far. A senior planning consultant will review your enquiry and explain your options and the next steps.